Power as well. The stationary sprinkler or

Published by admin on

Power Generating Lawn Sprinkler System: A
Comparative Analysis

Power generating lawn sprinkler system is a power generator induced method of
water diffusion, an advanced system of irrigation used predominantly to
regulate airborne dust and is important for the development of agriculture
and other green areas including landscapes, lawns as well as golf courses.

Power generating lawn sprinkler system is a water-conservative
irrigation system as it is the encapsulates distribution of water as in most
irrigation procedures simultaneously through a system of pipes by pumping. This
water for irrigation is evenly spewed into the air through rotating sprinkler, unanimously
spreading as water drops equally unto the ground and its environs. Many at
times, power generating lawn sprinkler systems have an underground sprinkler
function through the use of electrical or electronic technology and hydraulic

We Will Write a Custom Essay Specifically
For You For Only $13.90/page!

order now

In the same vein, just as in other major acceptable sprinkler systems,
the Power generating lawn sprinkler system consists of various plumbing parts
including the pump unit, stationary sprinkler, piping and controller or
control equipment.

It possesses a stationary sprinkler also referred to as
a spray head which is used in smaller turf areas and may be used in landscape
beds as well. The stationary sprinkler or Spray heads is fixed such that the
head protrudes with its root to the ground and are stationary. These sprinkler
heads are known for spraying more of steam, compared to rotational sprinklers. The
spray heads are largely produced in sizes 4, 6 and 12 heights. Either of dimensions
could be used but must be subject to on the type of grass or the sprinklers precise
position in a land bed.

Secondly, the power generating lawn system is not
without a controller also called a control equipment. The sprinkler in most
cases runs from the controller equipment which is located on the interior or
exterior wall or partition that is used, or might operate from a central
control system.

It is however advised that in cases where the
sprinkler is connected to a distinct controller equipment, it is necessary to acquaint
oneself with how to switch or adjust the power off to the controller as this would
to a large extent curtail emergency situations in the event that the sprinklers
will not shut off.


This Power generating lawn sprinkler system can be used to generate
electric power by attaching a dynamo also referred to as a generator to the spinning
closed-head of the sprayer. Hence, the sprinkler is locked by the dynamo hence
converting it to a turbine.

Thereafter, upon activation, the dynamo or generator,
which sits on top of the valve makes way for air to discharge from the upper
part of a rubber diaphragm located in the centre of the valve. Meanwhile, the water
that has been gathered, and awaiting its charge, residing on the bottom of this
same diaphragm now has the higher pressure and lifts the diaphragm.
Immediately, the water under pressure that has been held down temporarily is given
a chance and is released downstream of the valve through a sequence of piping
that are in most cases made of PVC, a higher compression viable system or
polyethylene tube which are used in characteristically lower pressure
residential systems.

On reaching the end of these pipes, the generated water
just released is dispersed in an even style to its surrounding, the land level which
has been pre-determined and spaced out sprinklers. Interestingly, these
sprinklers can either have a fixed spray head that have a set pattern and commonly
spray between 1.5–2m (7–15 ft.), a completely round rotating sprinkler
that can spray a mildly interrupted stream of water from 6–12m (20–40 ft.),
or small drip sprayers or emitters that release a slow, gradual, and a
consistently steady drip of water on fainter vegetations such as flowers and bushes.

Pros and Cons of The Power Generating Lawn
Sprinkler System

It is worthy of note that the Power Generating Lawn Sprinkler System has
a more outweighing number of advantages than disadvantages. However, the
advantages are;

The produced power that is gotten from the power generating lawn sprinkler can
be used for energy or power requiring sprinklers such as remote controlled
electric sprinkler, lighting and other uses as it produces a continuous supply
of electrical power. It is even more reliable in cold times such as winter
where large quantity of electricity is produced.

Effective- If sprinkler devices just like the Power Generating Lawn Sprinkler
system are high-tech and are redesigned for both irrigation and power
generation, once installed, will generate low cost of energy requirements.

Can be
used to generate electric power- As power can be produced from sprinkler head in
core pivot sprinkler irrigation type, this is highly efficient especially as it
serves as a great help in developing countries. This is a paramount advantage
because these third-world countries are restricted in their allocations and budgets
channelled into their power sectors.


On the other hand, the disadvantages are as follows:

complexity – Power generating systems such as this require additional control
equipment and air pressure supply components which leads to an increased system
complexity. Hence, leading to a premium on proper and efficient maintenance.

A Higher
installation and maintenance cost –  The
increased complexity that is met with the power generating lawn system, there
is an added complexity pipe installation cost, and also an increased
maintenance expenditure.

Limited design
flexibility- limitations from the regulatory requirement and power generating
components are likely to may the number of individual sprinkler zones that is served
from a single riser as long as it is in the building, and impact the ability of
an owner to make system additions.




The Future of Power Generating Lawn Sprinkler

Power generating sprinkler irrigation one of the most
widely acclaimed, acceptable methods of sprinkling especially in agriculture.
It is an advanced method of sprinkling, embraced by advanced and developing
nations alike as it is an advanced water-saving irrigation technology. It is
widely acknowledged as the system is water conservative as water is absent from
the tube until the system runs, hence an immense contributor to the growth and
development of mechanised farming.

Furthermore, this sprinkler system has had a higher acceptability
rate as it is useful in hydropower generation. Hydro power is energy or power that
is gained from streaming, or flowing water and is used for watermills,
renewable energy, irrigation, and in the operations of mechanical devices.
Hydropower consist of broad categories including; conventional hydroelectric,
small hydro, micro hydro, conduit hydroelectricity, pumped storage
hydroelectricity and pressure buffering hydropower.

Categories: Development


I'm Iren!

Would you like to get a custom essay? How about receiving a customized one?

Check it out